11/3/2022 0 Comments Bcs sickle bar mower manual![]() ![]() Adding too much pressure will cause it to bind, add friction, and greatly shorten the life of the bar and guards. ![]() Most I have seen have a bolt and jam nut assembly. You loosen the jam nut and turn the bolt to increase tension on the bar. The material being cut releases liquids that help lubricate the cutterbar. If you feel you need more, just have some cheap veggie oil to dump on every now and again - but it really isn't necessary. If you're harvesting the hay, I'd hesitate to put anything on the cutterbar that I wouldn't be willing to eat. Grease zerks should be given a couple pumps daily or every 8 hours (seems there should be more than 2.). BCS SICKLE BAR MOWER MANUAL INSTALLIf there isn't one there yet, you should install a zerk on the main gearbox, remove the second bolt, and pump into the gearbox until grease comes out the other bolt hole. put the bolt back in and give it 5 more pumps. You got it right about throttle setting - at and idle or JUST above an idle. Running them faster is stressful on both you and the machine. Not sure if this will clarify anything any more than Farmerboybill. The previous owner may have been referring to tensioning the the mower blades with a ball peen hammer. For years I used sickle bar mowers in an orchard and sometimes the teeth would vibrate loose (over time). The teeth were held to the blade with metal rivets (pin) and the head of the rivets was hit to reshape the head of the metal rivet into a dome shape using a 3/16-inch punch and a ball-peen hammer. The peened metal rivets held the blades securely. Sometimes these would rattle loose on me, especially if I was trying to re-use an old pin.įinding the correct size pin was not always an easy task depending on the sickle bar I was working on. I don't know how bcs blades are attached or if they use a standard rivet size. Some older blades used odd metric sizes and that was a problem because "close enough" was never really good enough to keep things in place. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |